【STEEL BAR BENDING MACHINE】Our rebar bending machine comes with a bending and straightening frame, machine with two ways of use. When you need to straighten the rebar, just replace the upper module and you can use it. It can bend rebar 90° within 5 seconds and the bending range is up to 36mm 【PURE COPPER MOTOR】The electric hydraulic rebar bender uses a pure copper motor, which runs quietly and has low noise. It only turns on during bending to reduce unnecessary wear. In addition, the copper motor can greatly extend the life of the rebar bender 【FLEXIBLE AND PORTABLE】This handheld rebar bending machine has a heavy duty body and steel bending frame, which can bend super hard rebar, has strong clamping force and good heat dissipation, helping you reduce the waste of rebar and save time and effort 【PRESSURE RELIEF HANDLE】This electric rebar bender adopts a handheld design. Simply press and hold the switch and the bending block will start to push forward. It has a pressure relief handle. When the rebar angle you want is reached, push to release the pressure and the piston returns to its original position 【WIDELY APPLICABLE】This hydraulic rebar bending machine is mainly used in construction sites, railway construction, bridge construction, factory workshops, helping you easily handle the bending of various rebar such as rebar, round steel, threaded rods, steel columns, etc