1pcs 8.3mm twist drill , 1pcs M8x1.25 screw tap, 1pcs installation tool, 1pcs breaking pin tool, 1pcs mini hexagonal wrench, 25pcs M8 thread insert. Attention: Before you buy this kit, please make sure which size do you need. There is a limit screw on thread insert installation spanner, which can control the push depth of thread inserts. 135° angle of twist drills, with stronger metal penetration and higher efficiency 1. Drill out the injured thread with the drill bit. 2. Check the thread and pitch of the tap and the bolt match. 3. Use the specific taps for cutting the holding thread into the cleared hole. 4. Place the insert on the installation tool and center the insert in the slot. Wind the insert in with gentle downward pressure until half rotation below the . 5. punch the punch with the hammer instantaneously to remove the tail M8 thread inserts is made of stainless steel, installation tool and breaking pin tool electrophoresis treatment, sturdy, not easy to corrode. Twist drills and M8 screw taps are made of HSS (high speed steel), which has better wear resistance and heat resistance. The thread repair insert kit is suitable for all metals, composites, polymers, and other materials, and can be widely used in automotive and plumbing applications, such as restoration and replacement of stripped or damaged internal screw threads, guaranteeing long-lasting results for the bolt, motor plug, and spark applications, it's an essential tool for any or DIY enthusiast, ideal for automotive and engine repairs, Manufacturer: Akfldms