No Damage To Walls, Copper or Supply Lines: This compression sleeve puller is engineered to remove leaking sleeves, nuts and ferrules from 1/2 inch copper water compression fittings without cutting or cracking pipes. Its precise fit protects surrounding walls and finish work, ideal for tight plumbing spaces. Easy To Use Step‑by‑Step: First, remove the old compression fitting or angle stop. Next, place the pipe nut into the golden threaded mouth of the puller tool and tighten the . Confirm the ferrule puller is aligned with the pipe, then turn the handle about ten times. The tool automatically pull off the nut and ferrule. Saves Time vs Cutting Old Pipes: When there is not enough exposed copper to cut off an old compression fitting, this angle stop puller quickly removes the existing compression ring and reforms the previously crimped copper pipe back into a clean, round shape. Greatly shortens project time and simplifies replacement work. Works On Corroded & Supply Stops: Built from , ‑ and wear‑ materials, this ferrule puller easily tackles severely corroded or supply stops. Simply turn the lever to steadily extract the old compression sleeve from the pipe, reducing risk of breakage and extra repairs. Purchase With Confidence & Wide Use: Ideal for replacing quarter‑turn valves on dishwashers, sinks and toilets that use compression fittings. This sleeve remover tool is a smart addition to any plumber or DIY toolkit., Weight: 0.5291094288 pounds, Manufacturer: Xnuiasqe