Tooth use steps: 1. Measure the length of the bundled object plus about 15cm per week, cut a section of stainless steel strip and bend one end by 1-2cm. 2. The wire mouth of the buckle is against the bending direction and penetrates into the tie. L type use steps: 1.Measure the length of the bundled object plus about 15cm per week, cut a section of stainless steel strip and bend one end by 1-2cm. 2.The wire mouth of the buckle is against the bending direction and penetrates into the tie. 3. Make a circle around the object to be bundled, and the other end through the buckle and leaves a section.4. Tighten the cable tie with cable tie pliers and bend it in reverse. 5. Cut off the cable tie and use a hammer to hammer the buckle ears tightly. 6. The installation is complete. 3.Wrap around the object to be bundled, and the other end through the buckle and leaves a section. 4.Tighten the cable tie with cable tie pliers and reverse bend. 5.Cut off the cable tie and tighten the buckle ear with a hammer. 6.Installed., Weight: 1.7526749829 Pounds, Manufacturer: Hipzeepo