Self-drilling metal plasterboard anchor for a fast, hassle-free fixing wherever a timber or metal stud isn't available, driving straight into the board without a pre-drilled pilot hole, dowel or special setting tool. The self-drilling tip cuts its own thread as the anchor is driven home, so there's no need to switch between a drill bit and a screwdriver, no dowel to lose down a stud cavity, and no special setting tool to buy - just a Pozidriv or Phillips screwdriver, or a low-speed driver bit, and a few turns. Each anchor is precision die-cast from zinc alloy, giving a considerably higher load capacity and greater long-term durability than standard nylon or plastic wall plugs, while staying light enough to drive home with an ordinary screwdriver or a low-speed driver bit. A wide flange seats flush against the board face once fully driven, spreading the load around the fixing point and leaving a neat, finished appearance. Because this anchor forms its own hole as it's driven, fitting is a one-step job, with less risk of an underprepared or oversized hole leaving the fixing loose before the screw has even gone in.