Detection Radius – 360 Degrees | Detection Range – 6m Max (<24°C) | Installation Height – 2.2m to 4m | IP44 – Suitable protection against weather & water sprays from any direction OCCPANCY – With traditional PIR’s, once the timer has started, that’s it, you would then have to wave your hand or move when the light goes off to reset the light which can be frustrating. Our occupancy sensors will constantly reset their timer providing someone is within the sensors range. This means that any connected lights will only turn off when the switch hasn’t detected movement for your selected period of time. Lux – Our occupancy sensors have a lux setting which will only allow your lights to be turned on when a light level falls below are certain point & when motion is detected. For example, your garden lights won’t come on during the day when you walk past them if you set the correct lux level. Timer – When the switch is triggered, it will keep your lights on for a certain period of time. This switch has the following timer settings: 10 Seconds, 30 Seconds, 90 Seconds, 3 Minutes, 7 Minutes or 15 minutes. When motion is detected by the sensor, the timer will reset. If required, more than one of these PIR switches can be linked in parallel to make a circuit live, this could be useful at the top and bottom of a stair case… Or in a larger space when all lights in that space need to be turned on at the same time, no matter where motion is detected in that space.